How do you know when a mine has reset?

ValleyValley Member
in Help Requests 34.85 Karma
Title ^

Comments

  • Wade PrevossWade Prevoss Member
    31.50 Karma
    Just Check it If You Can Enter Or Not?
  • ValleyValley Member
    34.85 Karma
    Oh okay thankyou Luca
  • SuperxtremeSuperxtreme The NetherlandsGame Moderator
    46.25 Karma
    What I do: I pull a block near the entrance before I leave the mine. So I know when I enter that mine again, if it has reset or not.
  • medicationsmedications Member
    75.75 Karma
    I leave marks on the specific mine, then going back there after few minutes
  • ValleyValley Member
    34.85 Karma

    What I do: I pull a block near the entrance before I leave the mine. So I know when I enter that mine again, if it has reset or not.

    Thanks that’s a good idea
  • edited March 2018 120.75 Karma
    It would help if we all began leaving a mark if we have swept a mine or not, I know non forumers will not know to leave a mark when egg hunting but we can spread awareness. I say we all start pulling the 2nd tile in front of the door when sweeping a mine.
  • DsBerrypawDsBerrypaw Member
    94.05 Karma

    It would help if we all began leaving a mark if we have swept a mine or not, I know non forumers will not know to leave a mark when egg hunting but we can spread awareness. I say we all start pulling the 2nd tile in front of the door when sweeping a mine.

    When in mountain mines that may be a challenge to see.... Maybe we could leave 1 piece of dirt on top of the door plus the second tile? I dunno...
  • 0.25 Karma

    Just Check it If You Can Enter Or Not?

    You usually can't immediately re-enter a mine after leaving, but I don't think that has any influence on when it has reset. I think it's an internal timer that starts when there are no Qbees in the realm, then after that timer has elapsed the realm resets itself, as if no digging has occurred...
  • b3achyb3achy Member
    51.45 Karma
    I always pull a couple of blocks near the entrance to the mine and leave them bouncing. It's more of a warning to people that are entering that someone is in there since there are no flags on the mines in the overworld (and some people don't check the skymap - though often it's not right either as I've entered what should empty mines and there are folks talking when I get there). Pulling the blocks also makes it easy to tell if the mine has reset if I'm jumping from mine to mine gathering ore (or hunting easter eggs).
Sign In or Register to comment.